Description

The ARK Pixhawk Autopilot Bus (PAB) Carrier is based on the Pixhawk Autopilot Bus open source specification. The Pixhawk Autopilot Bus (PAB) form factor enables the ARK PAB Carrier to be used with any PAB flight controller such as the ARKV6X.

• Pixhawk Autopilot Bus (PAB) Form Factor
• Connectors
  • PAB Board to Board Interface
    • 100 Pin Hirose DF40
    • 50 Pin Hirose DF40
  • Dual Digital Power Module Inputs
    • 5V Input
    • I2C Power Monitor
    • 6 Pin Molex CLIK-Mate
  • Ethernet
    • 100Mbps
    • Built in Magnetics
    • 4 Pin JST-GH
  • Full GPS Plus Safety Switch Port
    • 10 Pin JST-GH
  • Basic GPS Port
    • 6 Pin JST-GH
  • Dual CAN Ports
    • 4 Pin JST-GH
  • Triple Telemetry Ports with Flow Control
    • 6 Pin JST-GH
  • Eight PWM Outputs
    • 10 Pin JST-GH
  • UART/I2C Port
    • 6 Pin JST-GH
  • I2C Port
    • 4 Pin JST-GH
  • PPM RC Port
    • 3 Pin JST-GH
  • DSM RC Port
    • 3 Pin JST-ZH
  • RC/SBUS Port
    • 5 Pin
  • USB
    • USB C
    • 4 Pin JST-GH, in parallel with USB C
  • SPI Port
    • 11 Pin JST-GH
  • ADIO Port
    • 8 Pin JST-GH
  • Debug Port
    • 10 Pin JST-SH
• USA Built
  • NDAA compliant
  • FCC compliant
• Power Requirements
  • 5V
• Dimensions (Without Flight Controller Module)
  • 74mm x 43.5mm x 12mm
  • 22g

*Requires a Pixhawk Autopilot Bus compliant flight controller such as the ARKV6X

Documentation

3D Model