ARK Boson Adapter

$158.00

Teledyne FLIR Boson+ breakout to MIPI CSI-2 with serial port and onboard IMU

In stock

Description

The ARK Boson Adapter breaks out the Teledyne FLIR Boson+ thermal camera module into standard, easy to integrate connectors. The Boson+ plugs directly into the 80 pin board to board connector on the bottom of the adapter, and the adapter provides a 22 pin MIPI CSI-2 FFC for the thermal video and a 6 pin JST-GH port for the Boson serial port and the onboard IMU. The camera port powers the Boson and carries the I2C the driver controls it over, so video needs only the one FFC cable. Drivers and overlays ship in the ARK Jetson and ARK Just A Pi images.

An onboard ICM-45686 6-axis IMU shares the control port. The Boson frame sync line runs to the camera port for host timestamping and to the IMU frame sync input for tightly synchronized camera and inertial measurements.

  • Boson Module Connector
    • Hirose DF40 80 pin board to board (bottom side)
    • Supports Teledyne FLIR Boson+ cameras with the MIPI interface only, not the USB versions
  • Thermal Video Output
    • 22 pin 0.5mm pitch MIPI CSI-2 FFC connector
    • 2 data lanes plus clock
    • 640 x 512 at 60 fps, colorized by the Boson or 14 bit pre-AGC
    • Boson I2C control on the FFC, so video needs no other cable
    • Supported on the ARK Just A Jetson, ARK Jetson PAB Carrier and ARK Just A Pi (CM5)
  • Control Port
    • 6 pin JST-GH with the Boson serial port and the IMU I2C, 3.3V level translated
  • Onboard IMU
    • TDK InvenSense ICM-45686 6-axis accelerometer and gyroscope
    • Frame sync input connected to the Boson frame sync line
  • Power
    • 3.3V from the camera port powers the Boson and the adapter
  • USA Built
    • NDAA compliant
  • Mounting
    • 4x 1.8mm mounting holes
  • Included
    • 22 pin to 22 pin 0.5mm FFC camera cable
    • 22 pin to 15 pin 0.5mm FFC camera cable
    • 6 pin JST-GH cable
  • Dimensions
    • 21mm x 21mm x 6mm
    • 2.5g

*Teledyne FLIR Boson+ camera module not included. Only the MIPI versions of the Boson+ work with this adapter. The USB versions do not.

*Requires a host with a 22 pin or 15 pin MIPI CSI-2 camera input and the ARK Boson+ driver, currently the ARK Just A Jetson, ARK Jetson PAB Carrier and ARK Just A Pi

*Rev 1.0: the Boson serial port TX and RX are swapped on the control port. Cross pins 2 and 3 of the included straight 6 pin cable to use the Boson serial port. Video and the IMU are not affected.

Documentation

3D Model

Additional information

Weight 2.5 g
Dimensions 2.1 × 2.1 × 0.6 cm
Weight

2.5 g