Description
The ARK Hadron Adapter breaks out the Teledyne FLIR Hadron 640R / 640R+ dual EO/IR camera module into standard, easy to integrate connectors. The Hadron plugs directly into the 50 pin board to board connector on the bottom of the adapter, and the adapter provides a 22 pin MIPI CSI-2 FFC for the EO (visible) camera, a JST-GH USB port for the IR (thermal) camera, and a JST-GH I2C port for Hadron control. Drivers and overlays ship in the ARK Jetson and ARK Just A Pi images.
An onboard ICM-45686 6-axis IMU shares the Hadron control I2C bus, and its frame sync input is wired to the Hadron frame sync line, so every sync pulse from the thermal camera is tagged in the IMU data for tightly synchronized camera and inertial measurements.
- Hadron Module Connector
- Hirose DF40 50 pin board to board (bottom side)
- Supports Teledyne FLIR Hadron 640R and Hadron 640R+
- EO Camera Output
- 22 pin 0.5mm pitch MIPI CSI-2 FFC connector
- 4 data lanes plus clock, also runs on 2 lane ports
- Camera I2C, reset and frame sync on the FFC
- Supported on the ARK Just A Jetson, ARK Jetson PAB Carrier V3, ARK Jetson PAB Carrier (15 pin ports, cable included) and ARK Just A Pi
- IR Camera Output
- USB 2.0 on a 4 pin JST-GH connector, UVC camera
- Powers the Hadron and the adapter from the 5V USB supply
- Hadron Control Port
- I2C on a 6 pin JST-GH connector, 3.3V level translated
- Carries the Hadron I2C and the onboard IMU
- Onboard IMU
- TDK InvenSense ICM-45686 6-axis accelerometer and gyroscope
- FSYNC wired to the Hadron frame sync line for camera and IMU synchronization
- USA Built
- NDAA compliant
- Mounting
- 4x 1.8mm mounting holes
- Included
- 22 pin to 22 pin 0.5mm FFC camera cable
- 22 pin to 15 pin 0.5mm FFC camera cable
- 4 pin JST-GH cable
- 6 pin JST-GH cable
- Dimensions
- 33mm x 47mm x 6mm
- 8.0g






