We’re excited to announce the launch of the ARK Boson Adapter and ARK Hadron Adapter — available now.
Both are made in the USA and NDAA compliant. Each one takes a Teledyne FLIR camera module on its board-to-board connector and brings the camera out on standard connectors: a MIPI CSI-2 ribbon for video and JST-GH ports for control. Each has an onboard TDK InvenSense ICM-45686 IMU with its frame sync input wired to the camera’s sync line, so every frame is tagged in the IMU data. Drivers and overlays ship in the ARK Jetson and ARK Just A Pi images.
ARK Boson Adapter

The ARK Boson Adapter is a breakout for the Teledyne FLIR Boson+ thermal camera with the MIPI interface. The camera ribbon carries the video, the power, and the I2C the driver controls the Boson over, so video needs no other cable. The Boson’s serial port and the IMU are on a 6-pin JST-GH. Two FFC cables and a 6-pin JST-GH cable are included.
- Teledyne FLIR Boson+, MIPI versions, on an 80-pin board-to-board connector (camera not included)
- 2-lane MIPI CSI-2 on a 22-pin 0.5 mm FFC, 640×512 at 60 fps, colorized by the Boson or 14-bit pre-AGC
- Boson serial port and the ICM-45686 IMU on a 6-pin JST-GH, with the IMU frame sync wired to the Boson sync line
- Works with the ARK Just A Jetson, ARK Jetson PAB Carrier, and ARK Just A Pi
- 2.1 cm × 2.1 cm × 0.6 cm and 2.5 g
- USA built and NDAA compliant
$158
ARK Hadron Adapter

The ARK Hadron Adapter is a breakout for the Teledyne FLIR Hadron 640R and 640R+ dual EO/IR camera module. The visible camera comes out on a 22-pin CSI-2 ribbon, the thermal camera on USB, and the Hadron’s control I2C on a 6-pin JST-GH that it shares with the IMU. Two FFC cables, a 4-pin and a 6-pin JST-GH cable are included.
- Teledyne FLIR Hadron 640R and 640R+ on a 50-pin board-to-board connector (camera not included)
- EO camera: 4-lane MIPI CSI-2 on a 22-pin 0.5 mm FFC, also runs on 2-lane ports
- IR camera: USB 2.0 UVC on a 4-pin JST-GH, which also powers the Hadron and the adapter
- Hadron I2C and the ICM-45686 IMU on a 6-pin JST-GH, with the IMU frame sync wired to the Hadron sync line
- Works with the ARK Just A Jetson, ARK Jetson PAB Carrier V3, ARK Jetson PAB Carrier, and ARK Just A Pi
- 3.3 cm × 4.7 cm × 0.6 cm and 8 g
- USA built and NDAA compliant
$197
Jetson and Just A Pi setup instructions are in the documentation. Both adapters are in the new Cameras category in the store.